This is Why Using a Push Stick with Your Table Saw is So Important


chair

What is Table Saw Kickback?

Table saw kickback happens when a board trapped between the blade and the fence gets flung back at you after the cut is completed. The results can be dangerous, as you can see from the photo above. This particular mishap occurred while I was ripping 1/4-in.-thick splines for a hardwood floor. I made the mistake of using a push stick that was so shredded from overuse that the board kicked back and blew right under it, skewering my chair!

Fortunately, there are several ways to safely rip thin strips. One of the easiest methods is shown below. This push stick, more accurately called a push block, somewhat resembles a shoe with a heel.

DIY push stick how to

To make one, cut a notch in a 16-in.-long 2×6 a bit shallower than the thickness of the board you’re ripping and about 12 in. long. The top—or sole—of the notch puts downward pressure on the board as it passes through the blade, preventing the board from being flung upward. The end of the notch—or heel—hooks over the end of the board. The block lets you to push the workpiece with your fingers safely away from the blade and keeps the board from being kicked back.

As you make the cut, be sure to slide the push block all the way past the blade to avoid a kickback involving the block!

Next, check out these tips for ripping boards on a table saw safely.

wood

Next, check out DIY Magnetic Push Sticks.



Source link

Leave a Reply

Your email address will not be published. Required fields are marked *