How to Make a Modern Outdoor Fireplace


There’s a secret inside this outdoor fireplace

This outdoor fireplace looks like a solid concrete cube, but this hollow box holds a standard propane tank and regulator—the same components that fuel a typical gas grill. Just remove the burner and lift out the tank when it needs to be refilled. The door provides access to the burner controls.

FH19MAY_594_54_036-1200 outdoor fireplace

It’s really easy, but …

This outdoor fireplace project involves mostly cutting parts and driving screws—simple stuff. But it does include some materials and methods that might be unfamiliar to you:

  • STEEL STUDS are the best choice for the inner structure of the box. Unlike wood, they’re unaffected by heat and humidity. If you haven’t worked with steel studs before, don’t worry—you’ll probably find them easier than conventional lumber. For tips on building with steel, search for “steel studs” at familyhandyman.com. Note: Steel studs in contact with soil will eventually rust away, so the box base is pressure-treated wood.
  • BACKER BOARD, normally used under ceramic tile, forms the outer shell of the box. I used 1/4-in.-thick GreenE-Board, which is made from lightweight magnesium oxide. Any exterior-rated backer is fine, except versions that have a foam core, which may not stand up to heat.  For information on types of backer board and how to work with it, go to familyhandyman.com and search for “tile backer.”

The fuel and flame system

Propane burners are available online in various sizes and shapes. I used a 19 x 19-in. stainless steel version with a built-in igniter. The AZ GSF burner connects to a standard  20-lb. propane tank, which provides about 20 hours of use.Some burners have a control panel that can be mounted on the exterior of the fireplace. Mine didn’t, so I installed an 8 x 8-in. stainless steel access door (Acudor ED-2002). I glued the door in place with construction adhesive.

Decorative “fire pebbles”fill the burner tray. To protect the burner from rainwater and other elements when not in use, I applied foundation coating to a leftover scrap of backer board.

Foundation coating

FH19MAY_594_54_037-1200 outdoor fireplace

Foundation coating covers the backer board on this outdoor fireplace. It’s kind of like super-thick paint mixed with fine sand, so it gives the look of concrete without the weight and backbreaking labor. I used FlexCoat, which is available in various colors. Before brushing on the coating, wipe dust off the box and apply backer board tape to the corners. The tape may not stay in place for long, so apply the coating right away.

Cutting List

OutdoorFireplace_CuttingList-1200

Outdoor Fireplace Plans

FH19MAY_594_54_T01-1200 outdoor fireplace

WARNING: Ventilation is mandatory: A gas leak would fill the box with propane. That’s a potential explosion. To ventilate the box, I used a hole saw to bore four 1-in. holes on two sides of the box. That way they’d be hidden by the deck but still allow leaked propane to escape.

Build Four Walls

FH19MAY_594_54_004-1200 outdoor fireplace

Slip each stud into the tracks, clamping them into place with locking pliers. Drive screws on one side of the wall only. Place the end studs with the open side facing inward.



Source link

Leave a Reply

Your email address will not be published. Required fields are marked *